Touch Pattern

You must enter a PIN code to enter the settings screen.

There are four modes of touch verification setup:

(1) Default Mode

(2) Counting Mode

(3) Sequence Mode

(4) I/O Mode

Except for the default mode, each mode can only be applied after a successful simulation test.

Default Mode

Default mode: touch the aluminum shell to complete the login.

Counting Mode

verification succeeds when the first light signal at which the user starts to touch the shell and the last light signal at which the user stops touching matches the setting.

Sequence Mode

Set up to 5 color sequences. The sequence and light numbers must match the setting. After the user sets it, it can be applied after a successful simulation test.

 I/O Mode

At this mode, verification succeeds when the first light signal at which the user starts to touch the shell and the last light signal at which the user stops touching matches the setting. It can only be applied after a successful simulation test.

Test

When testing the function, the AuthTron® tail light will flash five cycles in the order of red, green and blue. Please touch the aluminum shell according to your settings, and it can be officially applied after passing the simulation test.